Grundig GNU 41820 X User Manual

38
DISHWASHER / USER INSTRUCTIONS
/55 EN
Troubleshooting
• Rinse aid is not sufficient. >>> Check the rinse aid indicator and add rinse aid if
necessary. Increase the rinse aid setting if there is enough amount of rinse aid in the
machine.
• Machine is unloaded right after the programme is over. >>> Do not unload your machine
right after washing process is completed. Slightly open the door and wait for evacuation
of the steam inside for a while. Unload the dishes after the pieces cool down to a
touchable level. Start unloading process from the lower basket. Thus, dropping of water
remained on a piece at upper basket onto the pieces at lower basket is prevented.
• Selected programme is unsuitable. >>> Since rinsing temperature is low at programmes
with short duration, drying performance will also be low. Select programmes with longer
duration for a higher drying performance.
• Surface quality of the kitchen utensils is deteriorated. >>> Desired washing performance
can not be obtained on kitchen utensils with deteriorated surfaces and it is not suitable
to use such utensils in terms of hygiene as well. Also, water can not flow easily on
deteriorated surfaces. It is not recommended to wash such kitchen utensils in dishwasher.
C
It is normal that drying complaints can be experienced with Teflon kitchen
utensils. It is associated with the structure of Teflon. Since the surface tensions of
Teflon and water are different, water droplets will remain as beads on the Teflon
surface.
Tea, cafe or lipstick stains remain on dishes.
• Selected programme is unsuitable. >>> Select a programme with a higher temperature
and cycle time.
• Surface quality of the kitchen utensils is deteriorated. >>> Tea and cafe stains or other
dye spots may not be cleaned in dishwasher when they have penetrated in deteriorated
surfaces. Desired washing performance can not be obtained on kitchen utensils with
deteriorated surfaces and it is not suitable to use such utensils in terms of hygiene as well.
It is not recommended to wash such kitchen utensils in dishwasher.
• Detergent is stored under unsuitable conditions. >>> If you are using powder detergent,
do not store the detergent package in humid places. Keep it in a closed container if
possible. For ease-of-storing, we recommend you to use tablet detergents.
Lime traces remain on dishes and glassware gains a misty appearance
• Rinse aid is not sufficient. >>> Check the rinse aid indicator and add rinse aid if
necessary. Increase the rinse aid setting if there is enough amount of rinse aid in the
machine.
• Water hardness setting is low or salt level is insufficient >>> Measure the hardness of the
supply water appropriately and check the water hardness setting.
• Salt leakage exists. >>> Pay attention not to spill salt around the salt filling hole while
adding salt. Make sure that the salt reservoir lid is tightly closed after finishing the filling
process. Run the prewash programme to remove the salt that spilled inside the machine.
Since the salt granules that will remain under the lid will dissolve during prewash, causing
the lid loosen, check the lid once again at the end of the programme.

Grundig GNU 41820 X Specifications

General

Door color	Stainless steel
Control type	Buttons, Touch
Display type	LCD
Built-in display	Yes
Appliance placement	Undercounter
Control panel color	Black, Stainless steel
Noise level	44 dB
Delay start (max)	24 h
Number of place settings	13 place settings
Number of washing programs	8
Drying class	A
Annual water consumption	2800 L
Annual energy consumption	262 kWh
Water consumption per cycle	10 L
Energy consumption per cycle	0.92 kWh

Weight and Dimensions

Depth	548 mm
Width	598 mm
Height	820 mm