33/
EN
Floor illumination
Warning to show that machine is in
washing phase
(depends on the model)
Your machine reflects a light to the floor
during the washing process. This light turns
off after the washing process is complete.
Floor illumination is activated
automatically when the washing
programme starts and remains lit until
the end of the programme.
Floor illumination cannot be cancelled
by the user.
TurboWash Function
(Depends on model)
This function operates the lower impeller
with a higher pressure and higher speed to
enable a better washing for dishes such as
pans and trays with stubborn, dried soiling.
Auto Tablet Feature
(Depends on model)
Auto Tablet is a feature which detects
the use of combined tablet detergents
automatically.
Drying performance of these type of
detergents is improved by adjusting
temperature and duration accordingly.
Owing to this feature, there is no need
to press any button in case of a tablet
detergent use.
Feature can be activated if automatic
detection is desired.
To activate / to deactivate:
1. After switching your machine on, press
the settings key until the countdown 3,
2, 1 is completed on the display.
2. Press the programme key to activate
the a: position. Automatic detergent
detection feature is disabled in “a:0”
position and enabled in “a:1” position.
Set the desired option by pressing the
time delay key.
3. Press the On/Off key to save.
Interior Lighting
(depends on the model)
Some models have interior lighting to
illuminate the interior when the door is
opened.
1. After switching on your machine, press
the Settings key until the countdown 3,
2, 1 is completed on the display.
2. Press Program key to move to position
L: on the display. Interior lighting is
off in “L:0” position and on in “L:1”
position. Select the position you want
with the Time Delay key.
3. Switch off the machine with the On/Off
key to save the changes.
Doormatic
(Depends on the Model)
Thanks to the “Doormatic” feature on your
machine, the drying effectiveness of your
machine is improved and power is saved.
There are two options, namely “OFF” and
“ON”.
You may use sub-menu settings to change
“Doormatic” settings.
When you activate this function, the door
of your machine is opened automatically at
the end of the washing cycle.
Doormatic feature opens the door at
the end of the washing cycle thanks
to the “door opening shafts". This
process takes about 2 minutes. Do not
force to close the door if the power is
interrupted while the shafts are moving
out. Operation shall be completed
and shafts shall be retracted when the
power is restored.
Doormatic function may cause
changes to the cycle time.
To Next Page
Loading...
Need help?
General
