36/
EN
Child lock prevents the selected
programme or functions from being
changed and disables the Start / Pause
/ Cancel key.
Child lock does not lock the door of the
machine.
If you switch your machine off by
using On/Off key at the end of the
programme, the child lock will be
deactivated automatically.
For energy saving, the machine is
automatically switched off following the
completion of the programme or when
the programme is not started.
To cancel the child lock:
1. Press and hold the Child (Key) Lock
key.
2. “3”, “2”, “1” is displayed on Display
Information Line and key lock is
cancelled.
Cancelling the programme
1. Press and hold the Start / Pause /
Cancel key until the 3, 2, 1 countdown
is completed on the display.
2. Start / Pause indicator will start
flashing. For a couple of minutes,
the machine will fulfil the necessary
operations required to cancel the
programme.
There might be residues of detergent
or rinse aid left in the machine and/or
on the pieces being washed depending
on the step in which the programme
has been cancelled.
Salt ( ) indicator
Please check the salt indicator on the panel
of your dishwasher to see whether there is
adequate amount of softening salt in the
dishwasher or not. You need to refill the
salt reservoir with salt whenever the salt
Adjusting the amount of rinse aid
1. After switching your machine on, press
the Settings key until the countdown 3, 2,
1 is completed on the display.
2. Press Programme key to move to
position (P) on the display.
3. Set to the appropriate level with the Time
Delay key.
4. Press On / Off key to save the setting.
No rinse aid dispensed in P:0 wash position.
1 dose of rinse aid is dispensed in P:1
position.
2 doses of rinse aid are dispensed in P:2
position.
3 doses of rinse aid are dispensed in P:3
position.
4 doses of rinse aid are dispensed in P:4
position.
warning symbol lights on the panel of your
machine.
Adjusting the water hardness level is
explained in Water Softening System
section.
Rinse Aid ( ) indicator
Please check the rinse aid indicator on
the panel of your machine to see whether
there is adequate amount of rinse aid in
the dishwasher or not. You need to refill the
rinse aid dispenser with rinse aid whenever
the Rinse Aid indicator lights on the panel
of your machine.
Water Cut-off indicator ( )
Water Cut-off warning indicator will light
when the machine cannot take in water.
When the water is supplied again, the
warning light will turn off automatically.
Make sure that the water is not cut-
off and the tap is not closed when
the Water Cut-off warning light is
illuminated. Call Authorised Service
To Next Page
Loading...
Need help?
General
