35/
EN
Starting the programme
To start your machine after selecting the
programme and auxiliary functions, press
Start / Pause / Cancel key.
Once the programme starts, a tune is
played and the estimated time remained
until the end of the programme will appear
on the Display Information Line. Start /
Pause / Cancel indicator starts lighting
continuously.
Programme and auxiliary functions
cannot be changed after the
programme has started.
Your machine performs water softening
depending on the hardness level of the
mains water. Remaining time displayed
towards the end of the programme can
be different from the time indicated at
the beginning due to this process. The
total duration can also change while
the programme is running depending
on the ambient temperature where
your machine is installed, temperature
of the mains water and amount of the
dishes.
Pay attention not to open the door
of the machine when it is running.
Stop the machine by pressing Start
/ Pause / Cancel key if you have to
open the door. Then, open the door of
the machine. There may be a rush of
vapour when you open the door of your
machine; be careful. Close the door of
your machine and press Start/Pause/
Cancel key again. Programme will
resume running.
After the rinsing step the machine
will wait silent in pause mode for
some time in order to have the water
remaining in the machine and on the
dishes drained completely and to have
the water softener cleaned, and then it
will resume running in drying mode.
Programme step follow-up
You can follow-up the washing step in
which the current programme is in from the
Programme Follow-up indicator.
a) Washing indicator
b) Rinsing indicator
c) Drying indicator
d) End of Programme indicator
Indicators for Washing / Rinsing / Drying
will light respectively on the display
throughout the washing programme.
Indicator of a finished step will not go off,
but they will light by adding on each other.
When the programme is over, indicators of
washing steps go off and only the End of
Programme indicator lights.
None of the Programme Steps Follow-
up indicators will light while the Time
Delay is enabled.
After the rinsing step the machine
will wait silent in pause mode for
some time in order to have the water
remaining in the machine and on the
dishes drained completely and to have
the water softener cleaned, and then it
will resume running in drying mode.
Child (Key) Lock
You can prevent other people from affecting
and changing the programme flow and time
delay while the machine is running.
To activate the child lock:
1. Press and hold the Child (Key) Lock
key.
2. “3”, “2”, “1” is displayed on the Display
Information Line and the key lock is
activated.
To Next Page
Loading...
Need help?
General
