Chapter 5: Enclosure Installation
9. Install the next ladder wall heat shield (26) to the previous ladder wall heat shield (26) using bolts (6)
and nuts (5).
10.Attach the ladder wall heat shield (26) to the vertical channels (41) using bolts (4) and nuts (8)
except where the duct support is located.
NOTE: Use bolt (7) and nut (8) in the hole where the duct support is located.
Figure 5-12 Ladder wall heat shield panel
4
5/16 x 3/4 in. flange bolt SS (S-8956)
7
5/16 x 1 in. flange bolt SS (S-7447)
5
5/16 in. flange nut (S-10268)
8
5/16 in. flange nut waxed (S-8452)
5/16 in. flange nut waxed (S-8452)*
26
Ladder wall heat shield (see parts)
6
5/16 x 3/4 in. flange bolt (S-6606)
41 Vertical channel
5/16 x 3/4 in. flange bolt SS (S-8956)*
* Use for stainless steel heat reclaimers.
PNEG-2016 Tower Dryer Heat Reclaimer
77
To Next Page