179
PART 3
(A) Quick Release Type
8. Install Front Wheel
GT Bicycle Owner’s Manual
• Insert the skewer though the hollow axle in the center of the hub. On a bike with disc brakes position
quick release lever assembly on the side opposite the brake disc.
• Reinstall the conical spring over the threaded end of the skewer, small end first.
• If quick release has a cam follower, a semicircular separate part, be sure it is properly aligned.
Yes! Semicurcular shape aligned with shaped
lever.
No! Semicircular shape is not aligned with
shaped lever.
• Reinstall the adjusting nut, threading it onto the threaded end of the skewer. Turn the adjusting nut
only a few turns at this stage. The critical final quick release adjustment will be made after the wheel
is installed in the fork.
To Next Page
Loading...
