Gtech MULTi K9 - Replacing the Filters

12
Remove the lter from the inner shroud,
by twisting and pulling.
Tap the inner shroud over a bin to remove
any excess dirt.
Wash the lter under a tap. Squeeze out
any excess water then let it dry completely
before reinserting into the AirRam K9.
Recommended water temperature 40°C.
Do not use detergent or soaps. Never put
the bin back without lter inside. You
could damage the motor.
Slide the lter onto the inner shroud. Slide the lter and inner shroud into the
lter housing.
Replacing the lters
2860_System_TE_K9_manual_update_aw.indd 12 31/05/2018 11:07