13
If the brush bar jams during use, the
AirRam K9 will stop and the LEDs will
appear red. Before checking for a blockage,
remove the battery.
Rest the AirRam K9 on its side and locate
the brush bar button on the right hand side.
Press the button inwards and then pull
the brush bar out from the bottom of
the AirRam K9.
The brush bar can now be removed,
starting at the button end.
To remove hair from the brush bar, run an
open pair of scissors down the groove to
cut the hair, then pull it out.
Removing and cleaning the brush bar
2860_System_TE_K9_manual_update_aw.indd 13 31/05/2018 11:07
To Next Page
Loading...
