14
If the brush bar jams during use, the
AirRam K9 will stop and the LEDs will
appear red. You will need to remove and
clean the brush bar (see page 11).
The AirRam K9 will not re-start until the red
lights go out. This will take ten seconds.
If the problem persists, follow the
troubleshooting instructions below.
Re-insert the brush bar, starting by the end
furthest away from the button. Then line up
and push the brush bar into the AirRam K9
until it clicks into place.
Replace the battery by sliding it down into
the head assembly. It will click into place.
10
seconds
Clearing a jam / fault
2860_System_TE_K9_manual_update_aw.indd 14 31/05/2018 11:07
To Next Page
Loading...
