6
Labels
GUARDIAN
HALO
Self-Retracting Lifeline
OSHA 1926.502 & 1910.140
WARNING!
Not suitable for leading edge use
Nunca deben usarse en aplicaciones
de borde expuesto
2
1
2
Prior to use, fully read and understand all manufacturer’s instructions provided with equipment at time of shipment. USE:
This device is only for use by one person as a fall arrester. Only make connections directly to attachment point on safety
harness. Guard against swing-fall by keeping the lifeline vertically overhead. Ensure that connection to anchorage is secured
properly before use. Avoid contact with sharp or abrasive edges and surfaces, and thermal, electrical, and chemical hazards.
May be used as a component of a PFAS in HLL applications. Design, installation, and utilization of HLLs must be supervised
by a Qualified Person. Unsuitable for horizontal use. Competent Person must calculate fall clearance prior to use; refer to
instructions for details. Clearance number specified is based on lifeline installed vertically overhead and in-line with worker.
INSPECTION: Prior to each use, inspect device per instructions, including locking function (sharp pull to test), retraction
function, legibility of labels, evidence of defects, damage, or missing parts, and condition of connectors, housing, fasteners,
and lifeline (inspect full length). Inspection by Competent Person required at least every 12 months. Immediately remove from
service if impact indicator on hook displays red. Lifeline: 3/16” (4,7 mm) Galvanized Steel Lifeline Length: 50 ft (15,2 m) User
Weight Range (including tools and equipment): 130-310 lb (59-141 kg)
Maximum Arresting Force: 1,800 lb (8 kN) Average Arresting Force: 900 lb (4 kN) Maximum Arresting Distance: 42 in (1,1 m)
Min. Fall clearance: 7 ft (2,1 m) Part#: 90513 Rev: G Serial # LOT # Mfg. Date Part # 10917 HEIGHT SAFETY. SIMPLIFIED.
guardianfall.com
Part # Date of Manufacture Lot # Serial # Date: Initials: Date of First Use:
1
To Next Page
Loading...
Need help?
General
