7
Diagram B - Fall Clearance
CAUTION! Fall clearance
calculation shown below is
based on a standing worker
falling directly in-line with
anchor point.
SAMPLE CALCULATION ONLY.
Always refer to connector
instructions for product-
specific clearance
information.
WARNING! Eliminate Swing Fall whenever
possible! Swing falls increase the risk of
striking objects or the ground in the event of
a fall. If swing fall exists, always account for
additional fall clearance.
■ Deceleration
■ Harness Stretch
■ Safety Factor
■ Swing Fall
Diagram A - Connections
1 ft 6 in (0.5 m)
2 ft (0.6 m)
3 ft 6 in
(1.1 m)
Maximum Arrest
Distance/
Deceleration:
3 ft 6 in (1.1 m)