5
M00000118- E-uk – 06.07 DL645 and Simplex 45
Section 1
Introduction
General
Please read this manual carefully, it contains information that will assist you with all aspects of
installation and maintenance, including unpacking, so that a long and useful machine life can be
achieved.
Gunnebo Entrance Control makes every effort to ensure that this manual is reviewed whenever
significant changes are made to the design. However, our policy of continuous improvement
may result in some small differences between the unit supplied and the description in this
document.
Enquiries in this respect should, in the first instance, be directed to our Technical Support
Department.
Telephone +44 (0) 1825 746105.
Electrical Warnings
The electrical power used in this equipment is at a voltage high enough to endanger life. Before
carrying out maintenance or repair, you must ensure that the equipment is isolated from the
electrical supply and tests made to verify that the isolation is complete.
When the supply cannot be disconnected, functional testing, maintenance and repair of the
electrical units is to be undertaken only by people fully aware of the danger involved and who
has taken adequate precautions and training.
Errors
Reports on errors, comments and suggestions concerning this manual are requested and
encouraged. They should be submitted to:
Gunnebo Entrance Control - Technical Support Department
Telephone +44 (0) 1825 746105.
Proprietary Notices
All data appearing herein is of a proprietary nature, with exclusive title to it held by Gunnebo
Entrance Control. The possession of this Manual and the use of the information is therefore
restricted only to those persons duly authorized by Gunnebo Entrance Control.
Do not reproduce, transcribe, store in a retrieval system or translate into any human or
computer language, any part of this Manual without prior permission of Gunnebo Entrance
Control.
Hardware Changes
No hardware changes may be made without authority from Gunnebo Entrance Control, who will
be responsible for ensuring that the proposed change is acceptable in all safety aspects. Only
personnel authorized by Gunnebo Entrance Control may make hardware changes.
Any maintenance or modification of Emergency Stop and Guarding Circuitry must be followed
by safety checks on the whole hardwired Emergency Stop and Guarding Circuitry.
Prior to a hardware change, records must be made of the change, one of which MUST be sent
to the Gunnebo Entrance Control Technical Department.
To Next Page
Loading...