17
Check if the mode were set as
slave mode, lightness and color
temperature of the products
cannot be controlled in slave
mode.
Pressthe“MODE”button for once,
switch the mode from slave mode
to master mode.
The brightness/
color temperature
knob is out of
control
APP can't
connect
Check if the product is “OFF”
because of the APP of the
mobile phone.
Press the “ON/OFF” button once
again.
The product is in
the "ON" state,
the display and
lights are not on
Check whether the device is
in APP
mode and whether
"BT_LED" is displayed on the
APP
Normal steps:
① Switch to APP mode after
turn on;
② Turn on bluetooth and GPS on
the phone
③ Open the APP, search and
connect to Bluetooth BT_LED
Check whether the color purity
SAT value is too low or 0; the
color purity value is 100, the
color difference is most obvious.
In RGB mode,
the lamp beads
have no RGB
color.
①
②
In the Master mode / Rotate
mode , li g h tly pr e ss th e
compound knob button to
switch to SAT, then turn the
compound knob button to
increase t
he color purity;
In WIFI mode, connect APP,
a d j u s t c o l o r p u r e SAT
through APP.
Phenomenon
Check the product
Solution
To Next Page
Loading...
