ADVANCED MEASUREMENT
43
AC+Hz Measurement
Applicable to
Background
The frequency measurement is not affected by the
MAX/MIN, REL, or Hold mode. In this mode, the
reading rate of the DMM may be slower than the normal
state.
1. Activate
AC+Hz
measurement
Press the SHIFT key and then press
C+Hz key.
SHIFT
2. Display
The second display shows the frequency of the input
signal.
Frequency
Hz
Hz Indicates Frequency measurement
Deactivate
AC+Hz
measurement
To cancel the AC+Hz measurement,
press AC+Hz again. The dBm mode
and AC+Hz mode can not be
selected concurrently.
Note
hen the input is less than the
sensitivity, the secondary display
shows.
hen the input frequency exceeds
51kHz, the primary display will
show.
To Next Page
Loading...
