GW Instek GDS-820 - Page 35

GDS-806/810/820/840 Programming Manual
34
:CURSor:X<X>Position
Select the cursors position of X axis.
Syntax
:CURSor:X<X>Position <NR1>
:CURSor:X<X>Position?
Arguments
<X>→Specify the cursor (1|2)
<NR1> is the desired position. For x-axis operation, the range is 1 to 249; for y-axis
operation, the range is 1 to 199.
Returns
<NR1>
CURSor:Y<X>Position
Select the cursors position of Y axis.
Syntax
:CURSor:Y<X>Position <NR1>
:CURSor:Y<X>Position?
Arguments
<X>→Specify the cursor (1|2)
<NR1> is the desired position. For x-axis operation, the range is 1 to 249; for y-axis
operation, the range is 1 to 199.
Returns
<NR1>