(30)s WP.VAR
Vernier control knob of the sweep time used when CAL and the sweep time is calibrated to the vh!ue preset in
TIMEDIV. The sweep of TIMEBIV can be varied continuously when shaft is not in CAL position. Rotate the control
knob to CAL position and the sweep time is calibrated to the preset value of the TIMEDIV. Counterclockwise rotate the
control knob to the bottom to delay the sweep by
2.5
time or more.
(32) POSITION
Adjust the trace or spot in horizontal position.
(31)X
10
MAG
Magnify 10 by pressing this key.
Function
Generator:
(39)GENERATOR OUTPUT
The main output terminal with 50
R
output impedance.
(40) WAVEFORM SELECTOR
The waveform change following after each button pushing in Sine wave, Triangle wave, and Square wave sequence.
(4
1
)OUTPUT WAVEFORM DISPLAY
Display the current output waveform.
(42)FREQ
RANGE Switch:
The frequency range changes following after each button pushing in
lM,
look, 10k,
1
k, 100, 10, and 1 sequence.
(43)FREQUENCY
RANGE
DISPLAY
Display the current frequency range.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
