GW Instek GOS-620FG - Page 21

AC POWER Input Circuit:
(36)AC Power input connector
Connect the AC power cord (supplied) to this connector.
(37)FUSE
& line voltage selector
Fuse rating is shown
in Page 7 Line voltage selector to select power sources.
(3 8)Studs
Studs
is not only used as a stand for laying the oscilloscope on its back to operate it in the upward posture, also used for
winding up the power cord.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com