GW Instek LCR-6200 - System:code; System:keylock; System:result; Common Commands

LCR-6000 Series User Manual
125
11.18.2 SYSTem:CODE
The SYSTem:CODE command feeds back error codes for each sent
command.
Command
Syntax
SYSTem:CODE {on,off}
Example
SEND> SYST:CODE ON<NL>
Query Syntax
SYSTem:CODE?
Query Response
{on,off}
Example
SEND> SYST:CODE?<NL>
RET> OFF<NL>
11.18.3 SYSTem:KEYLock
SYSTem:KEYLock command unlocks the keypad.
Command
Syntax
SYST:KEYLOCK OFF
or UNLOCK(UNLK)
Example
SEND> UNLOCK<NL>
11.18.4 SYSTem:RESult
SYSTem:RESult command selects the test results send mode.
Command
Syntax
SYSTem:RESult {fetch,auto}
Example
SEND> SYST:RES fetch<NL>
Parameter
Where,
fetch The test results will be sent back by command
“fetch?”.
auto The results will be sent back by one trig.
Query Syntax
SYSTem:RESult?
Query Response
{FETCH,AUTO}
Example
SEND> SYST:RES? <NL>
RET> fetch<NL>
11.19 Common Commands
11.19.1 *IDN?
The *IDN? query returns the instrument ID.
Query Syntax
IDN? Or *IDN?
Query Response
<model>,<firmware>,<serial no.>,<manufacturer>