GW Instek LCR-6200 - Table 4-3 Measurement and Monitor Parameter Descriptions

Measure Key
26
Table 4-3 Measurement and Monitor parameter descriptions
Parameter
Description
Cs
Capacitance value measured using the
series equivalent circuit model
Cp
Capacitance value measured using the
parallel equivalent circuit model
Ls
Inductance value measured using the
series equivalent circuit model
Lp
Inductance value measured using the
parallel equivalent circuit model
Rs
Equivalent series resistance measured
using the series equivalent circuit
model (ESR)
Rp
Equivalent parallel resistance
measured using the parallel equivalent
circuit model
Z
Absolute value of impedance
Y
Absolute value of admittance
G
Conductance
B
Susceptance
R
Resistance (=Rs)
X
Reactance
D
Dissipation factor
Q
Quality factor(=1/D)
θr
Phase radian
θd
Phase angle
Vac
Test signal Voltage
Iac
Test signal Current
Δ
Absolute deviation value
Δ%
Relative deviation value
DCR
Direct Current Resistance
Procedure for setting the measurement function
[FUNC]
Step 1. Press the [Measure] key.
Step 2. Press the [MEAS DISPLAY] soft-key if
[MEAS DISPLAY] is not already the active
mode.
Step 3. Use the cursor key to select [FUNC] field.
Step 4. Use the soft-keys to select measurement
function.