GW Instek LCR-914 Series - Setting Sorting Standards

LCR-914/915/916 User Manual
19
The default sorting standard value is the current value, and the
default tolerance is ±1.0%.
Setup Sorting Standard
To setup the sorting standard value, follow the steps below:
1. Press the SETUP button to enter the setup mode.
2. Press  and  button to setup the range of the standard
value. Then press the ENTER button to save the setup value
and enter the next step.
3. Press , ,  and  button to setup the standard value.
Then press the ENTER button to save the setup value and
enter the next step.
4. Press and button to setup the tolerance value. Then
press the ENTER button to save the setup value and exit this
mode.