GW Instek PEL-3000 Series - Page 14

3. If the unit doesn’t turn on, press the ON/STBY key
on the front panel.
 The ON/STBY key will go from standby (red)
to ON (green).
4. The unit will show the splash screen and then load
the settings from when the unit was last powered
down.
Load Default Settings
When first using the PEL-3000(H), recall the factory
default settings to ensure the unit is in a known state.
See the user manual for a list of the default settings.
1. Press
Shift
+
File
FUNC
.
2. Select Media/Default [F1].
3. Select Factory Default [F2].
4. Press Factory Default [F2] again to confirm.
Setting the Date and Time
The date and time settings are used to time-stamp files
when saving files.
1. Press
Shift
+
Utility
Help
> Time Set[F4] to set the
date and time.
Settings: Month, Day, Year, Hour, Minute