GWS PT-17 - Main Wing Assembly

PT-17
Qg»tnmiis
EPS400C POWER SYSTEM INSTALLATION
•TiV
Make a mark on the dummy engine for the power system Installation. (pic.1)
Cut the dummy engine as per the mark you just made. (pic.2,3)
Install the power system to the fuselage, (pic.4) (refer to page 5 power system installation)
Trail fix
the dummy engine into the power system, then glue it to the fuselage, (pic.5,6)
Install
the propeller & spinner, secure with a nut and washer, (pic.7,8)
° (HI)
o (B2,3)
mAmum^ - (•4) °
ffllfTKIfin °
(>5,6)
gJzllHig = (>7,8)
MAIN WING ASSEMBLY
^ M 0!) Si
sticker
stickern
Use Cutter Kn
• GWS glue the fiber glass for wing enforcement on the bottom of the wing, (leading edge) (Pic.16,17,18)
• Locate aileron linkage wire (L&R) and Black rubber tube(X2 pcs).(Pic.19)
P.S; Be careful of the color of stickers,@on white wing;@on yellow wing.
. M03x48OSiiiMAC£ltiraa6'2±:GWSl|fflP7i( . ° (816,17,18)
• » (hiq)
P.S: °
A
B
't":
-j--
Use Epoxy
- 6 -