GWS Spitfire - Tail Assembly

jV...U10mm
10mm
TAIL ASSEMBLY
$§ ^
saaa
15mm^ 30"!"^
< -* ->
40mm A 40mm
SPITFIRE
?Omm
Cut the elevators apart from the horizontal stabilizer with a knife as per the groove.(Pic.82,83)
Use a triangle to determine the center of the horizontal stabilizer and mark indication lines as
shown,(Pic.84) but wait to glue until.(Pic. 87)
Ensure that the horizontal stabilizer is perpendicular to the fuselage and vertical fin A=A'. (Pic.85)
Check the horizontal stabilizer with the wing and adjust the alignment as described. (Pic.86)
Make sure all is in place, then spread the glue on the horizontal stabilizer which contacts the
fuselage. (Pic.87)
Drill 1.5mm dia. deep hole on the aileron and cut a slot to accommodate the wire.(Pic.88,89)
Cut a slit at 2 places for the elevator and insert the elevator linkage wire securing with GWS glue.
(Pic.90,91,92)
Cut a slit (10mm x 10mm) at 4 places for hinge installation on the horizontal stabilizer and aileron.
(Pic.93,94,95)
Appy gws glue on all hinges and elevator llinkage wire and insert them into the horizontal stabilizer
securely.(Pic.96)
° (•82,83)
°
(184)
° (•85)
° (•86)
°
(^87)
]5$Uiyiit?fiZMi!IJllB5i^01.5mm5L ° (^88,89)
' M5i^u§yMtf^-tGwsii7mA5nB ° (•90,91,92)
'
I^BtSHBi^illBtJ.^^IOxlOmmtjn ° (•93,94,95)
°
(^96)
-12-