光毓机电 RMD-X8
V1.0
Attention
The motor input/output interface needs to keep the connection space, > 20mm is
recommended.
The length of mounting screws shall meet the requirements of the drawings. If too long
it will damage the internal structure. If too short may become loose.
Due to integrated reducer internal, the lubricating grease of the specified model 5-6ml
needs to be refilled every 1000H.
Axial load cannot be greater than 300N, radial load cannot be greater than 1000N.
Warning:
Please carefully read and follow the requirements in this manual, which will help you
set up and operate the drive correctly and achieve optimal drive performance.
Please install the equipment in a dry position, and should be non-flammable
surroundings
Please put in the place without grinding fluid, oil mist, iron powder, chip, etc.
Please put in well ventilated, dry and dust-free place.
Please put in non-vibration place.
Do not use gasoline, diluents, alcohol, acid and alkaline detergents to avoid
discoloration or breakage.
Requirements for the use of motion actuators:
Please ensure that this document is used by design engineers, installers, and those man
responsible for debugging the product.
Be sure to comply with the requirements of this document, as well as documentation
for other components and modules.
Please consider the legal requirements applicable to the place of using, including
—Regulations and standards
—Test organization and insurance company regulations
—National specification
To Next Page
Loading...
Need help?
General