Why won't my GYS Controller start the vehicle?
If your GYS Controller won't start the vehicle, ensure the switch is in the ON position. Also, the internal battery may be discharged, so charge the unit fully and try again. Allow 3 minutes between start attempts, and each start should not exceed 6 seconds. Finally, verify that the vehicle's battery voltage is 12V.
How to fix GYS GYSPACK PRO lamp that won't turn on?
If the lamp on your GYS Battery Charger does not switch on, the internal battery is likely discharged. Charge the unit and try again once the charge is complete.
What to do if my GYS GYSPACK PRO Battery Charger won't start and no LEDs turn on?
If your GYS Battery Charger can no longer start the vehicle and none of its LEDs switch on in "Test" mode, the internal batteries may have very low voltage or may be damaged. To attempt a recovery, put the device on charge. If the battery is damaged and cannot be recharged, you should contact the GYS after sale service to replace the battery.
Why does my GYS GYSPACK PRO keep beeping?
If your GYS Battery Charger device beeps, it indicates that the device has detected a polarity reversal. To resolve this, check the battery polarity.
Why are there sparks when connecting GYS Battery Charger clamps?
If you observe sparks when the clamps of your GYS Battery Charger make contact with the battery terminals, it could be due to the switch being in the «ON» position. Turn the machine off before connecting the clamps to the battery. Another cause could be incorrect placement of the negative and positive clamps on the battery terminals, indicating a polarity reversal. Ensure you check the battery polarity.
What to do if my GYS Battery Charger can't start the vehicle?
If your GYS Battery Charger unit fails to start the vehicle, there are several potential reasons: * The switch might be in the OFF position. Ensure it is set to the ON position. * The internal battery could be discharged. Charge the unit fully and try again. * You may have attempted several jump starts without sufficient pause. Wait 3 minutes between attempts, and limit each start to a maximum of 6 seconds. * The battery voltage of the vehicle may be incorrect. Verify that the vehicle's battery voltage is 12V.
What to do if the GYS Controller's charging LEDs do not activate?
If the charge of the internal battery of your GYS Controller does not start (none of the charging LEDs activate), check that the external charger plug is correctly connected to the socket of the machine.
Why does my GYS Controller keep beeping?
If your GYS Controller beeps, it indicates the device has detected a polarity reversal. Check the battery polarity.
How to fix a GYS Controller lamp that does not switch on?
If your GYS Controller lamp doesn't switch on, the internal battery may be discharged. Charge the unit fully, and try again after the charge is complete.
What to do if sparks appear when using the GYS Controller?
Sparks may appear when the clamps contact the battery terminals of your GYS Controller if the switch is in the «ON» position. Turn the machine off before connecting the clamps to the battery. Sparks can also appear if the position of the negative and positive clamps on the battery terminals is incorrect, so check the battery polarity.
Step-by-step guide to using the GYSPACK PRO for jump-starting a vehicle.
Detailed steps for connecting the device to vehicle battery terminals, including polarity considerations.
Instructions for operating the device to start a vehicle, including timing and attempt limits.
General| Input Voltage | 230V AC |
|---|---|
| Output Voltage | 12V / 24V |
| Type | Battery Charger |
| Battery Type | Lead-acid |
| Starting Current | 200A |
| Charging Modes | Automatic |
| Protection Features | Reverse polarity, short circuit |
To Next Page