What to do if the GYS Start UP 80 doesn't show 'end of charge' after a full day?
If the end of charge indicator on your GYS Remote Starter doesn't turn on after charging for a whole day, the battery is damaged and needs to be replaced.
Guidelines for safely connecting and disconnecting the device, including precautions against hazards like explosion and acid projection.
Procedures for device maintenance, cable replacement, and safe handling by qualified persons.
Information regarding regulatory compliance, conformity marks, and proper product disposal procedures.
Essential checks and preparations before connecting the device for charging.
Step-by-step guide for connecting and disconnecting the charger to the mains and battery.
Explanation of the automatic charging process, including status indicators and automatic stop.
Safety measures and conditions to observe before using the boost function.
Instructions for connecting and disconnecting the device for the boost function.
Details on the 10-minute pre-charge to facilitate engine starting.
Overview of the built-in protections for the device, including polarity inversion and thermal protection.
Information regarding the device's limitations with sulfated batteries and potential damage indicators.
Guidance on diagnosing and resolving common issues with the charger's indicators, charging, and fuse.
Schematic representation of the device's electrical layout.
Identification and part numbers for the various components used in the device.
Explanation of various icons related to batteries and their meanings.
Details on product specifications, environmental symbols, and noise level.
General| Charging source | AC |
|---|---|
| Battery capacity | - mAh |
| Battery technology | - |
| Number of simultaneously connected devices (max) | 1 |
| Built-in display | No |
Weight and Dimensions| Depth | 180 mm |
|---|---|
| Width | 120 mm |
| Height | 320 mm |
| Weight | 4400 g |
To Next Page
