H3C Mini Series

To Next Page

Preparing for installation

H3C Mini Unmanaged Ethernet Switches include the following

models:

• H3C Mini S8G-U (S8G-U).

• H3C Mini S9-PWR (S9-PWR).

• H3C Mini S16G-U (S16G-U).

• H3C Mini S24-U (S24-U).

• H3C Mini S24G-U (S24G-U).

Safety recommendations

To avoid any equipment damage or bodily injury, read the following

safety recommendations before installation. The recommendations

do not cover every possible hazardous condition.

• Do not place the switch near water or in a damp environment.

Prevent water or moisture from entering the chassis.

• Place the switch in a clean environment. Dust buildup on the

chassis might result in electrostatic adsorption, which reduces

lifespan of the device and can cause communication failure.

• Keep the air inlet and outlet vents of the switch free of

obstruction, and do not stack switches.

• Make sure the operating voltage is in the required range.

• Before using the switch, make sure the grounding cable of the

switch is correctly connected.

• Before cleaning the switch, remove the power cord from the

switch. Do not clean the switch with a wet cloth or liquid.

• Do not open the chassis while the switch is operating.

Need help?

Do you have a question about the H3C Mini Series and is the answer not in the manual?

H3C Mini Series Specifications

General

Series	Mini Series
Type	Unmanaged
Ports	5/8/16/24
MAC Address Table	8K
Power Supply	AC 100-240V, 50/60Hz
Dimensions	Varies by model (e.g., 100mm x 100mm x 28mm for 5-port)
Weight	Varies by model (e.g., 0.3kg for 5-port)
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Operating Humidity	10% to 90% non-condensing
Storage Humidity	5% to 95% non-condensing