H3C S5560X-EI Series Configuration Guide

28
Step Command Remarks
7. (Optional.) Enable
dynamic ARP entry
synchronization for
distributed VXLAN IP
gateways.
arp distributed-gateway
dynamic-entry
synchronize
By default, dynamic ARP entry
synchronization is disabled for distributed
VXLAN IP gateways.
When local proxy ARP is enabled on
distributed VXLAN IP gateways, each
gateway learns ARP information
independently. A gateway does not forward
ARP packets destined for it to other
gateways. For distributed VXLAN IP
gateways to have the same ARP entries, you
must enable dynamic ARP entry
synchronization.
A controller or the EVPN feature can also
synchronize ARP entries among distributed
VXLAN IP gateways. When you use a
controller or the EVPN feature, do not enable
dynamic ARP entry synchronization.
8. (Optional.) Enable
dynamic ND entry
synchronization for
distributed VXLAN IP
gateways.
ipv6 nd
distributed-gateway
dynamic-entry
synchronize
By default, dynamic ND entry
synchronization is disabled for distributed
VXLAN IP gateways.
When local ND proxy is enabled on
distributed VXLAN IP gateways, each
gateway learns ND information
independently. A gateway does not forward
ND packets destined for it to other gateways.
For distributed VXLAN IP gateways to have
the same ND entries, you must enable
dynamic ND entry synchronization.
A controller or the EVPN feature can also
synchronize ND entries among distributed
VXLAN IP gateways. When you use a
controller or the EVPN feature, do not enable
dynamic ND entry synchronization.
9. Enter VSI view.
vsi
vsi-name N/A
10. Specify the VSI
interface as the
gateway interface for
the VSI.
gateway vsi-interface
vsi-interface-id
By default, no gateway interface is specified
for a VSI.
Configuring a VSI interface
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter VSI interface view.
interface vsi-interface
vsi-interface-id
N/A
3. Assign a MAC address
to the VSI interface.
mac-address
mac-address
The default MAC address of VSI interfaces
is the bridge MAC address + 1.
4. Configure the
description of the VSI
interface.
description
text
The default description of a VSI interface is
interface-name plus
Interface
(for example,
Vsi-interface100 Interface
).
5. Set the MTU for the VSI
interface.
mtu
mtu-value
The default MTU of a VSI interface is 1500
bytes.

H3C S5560X-EI Series Specifications

General

Brand	H3C
Model	S5560X-EI Series
Category	Switch
Language	English