What to do if H3C S5500-EI Switch AC input fails?
If you experience an AC input failure with your H3C Switch, first check whether the power cord is properly connected to the switch. Next, verify that the external AC power supply system is functioning correctly. Lastly, ensure the switch's operating temperature is normal and that the power supply has adequate ventilation.
What to do if H3C S5500-EI RPS input fails?
If the RPS input fails on your H3C switch, verify that the switch is securely connected to the external RPS power supply. Then, check to ensure the external RPS power supply is working correctly. Finally, confirm that the switch's operating temperature is within the normal range and that the power supply has good ventilation.
How to fix H3C S5500-EI Switch software loading failure?
To resolve a software loading failure on your H3C switch, first check the physical port connections and reconnect them correctly if needed, then restart the loading procedure. Also, review the loading procedure information displayed on the HyperTerminal for any input errors and correct them before restarting. If problems persist, it is recommended to contact your agent for assistance.
What to do if I forgot the H3C S5500-EI Switch user password?
If you've forgotten the user password for your H3C Switch, enter the Boot Menu, select option 7, and then restart the switch. After the switch restarts, the user password will be removed.
What to do if H3C S5500-EI Switch configuration system fails and there is no terminal display?
If the configuration system fails on your H3C Switch and there is no terminal display, check that the power supply is working correctly. Also, verify that the console cable is properly connected.
What to do if H3C S5500-EI configuration system fails with illegible terminal display?
If the configuration system fails on your H3C Switch and the terminal display is illegible, check that the terminal parameter settings are correct. Ensure the baud rate is 9,600, parity is set to none, flow control is set to none, and terminal emulation is VT100.
General| Model | H3C S5500-EI Series |
|---|---|
| MAC Address Table | 16K |
| Jumbo Frame | Up to 9216 bytes |
| Operating Temperature | 0°C to 45°C |
| Operating Humidity | 10% to 90% (non-condensing) |
| Storage Temperature | -40°C to 70°C |
| Storage Humidity | 5% to 95% (non-condensing) |
| Managed | Yes |
| Layer | Layer 3 |
| VLAN support | Yes |
| Ports | 24/48 x 10/100/1000BASE-T |
| Power Supply | AC 100-240V, 50/60Hz |
| Dimensions (W x D x H) | 440 x 44 mm |
| Switch Type | Managed Layer 2/3 Switch |
| VLANs | 4094 |
| PoE Support | Optional (PoE and non-PoE models available) |
To Next Page
