H3C S5500-EI Series User Manual

Quick Start
H3C S5500-EI Series Ethernet Switches
Chapter 3 Installation
3-17
II. Connecting the AC Power Cable
1) Connect one end of the grounding cable to the grounding
screw on the rear of the chassis and the other end to the
ground as near as possible.
2) Connect one end of the power cable to the power socket on
the rear panel, and the other end to the AC power supply.
3) Install the power cable retainer for the AC power cable.
Insert the two ends of the power cable retainer into the slots
at both sides of the AC power socket, and then set the power
cable into the notch of the power cable retainer.
(1) Rear panel of the switch (2) Power cable retainer slots
(3) AC power cable retainer (4) AC power cable
Figure 3-16 Installing AC power cable retainer

H3C S5500-EI Series Specifications

General

Brand	H3C
Model	S5500-EI Series
Category	Switch
Language	English