EasyManuals Logo

H3C SecPath F5030 Configuration Guide

H3C SecPath F5030
39 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
5
For more information about the command, see DHCP commands in Layer 3–IP Service
Command Reference.
{ Obtain an IP address by using the modem-manufacturer's proprietary protocol.
IPv4:
ip address cellular-alloc
IPv6:
ipv6 address cellular-alloc
{ Configure an IP address manually.
ip address ip-address { mask-length | mask } [ sub ]
By default, no IP address is configured for an Eth-channel interface.
Configuring a 3G/4G network
Restrictions and guidelines
Both 3G and 4G modems can access GSM, CDMA2000, TD-SCDMA, and WCDMA networks. Only
4G modems can access LTE networks.
A 3G/4G modem is used to search a public land mobile network (PLMN) for accessible mobile
networks. A PLMN is uniquely identified by the mobile country code (MCC) and the mobile network
code (MNC). Some 3G/4G modems can automatically access a mobile network. To manually specify
a mobile network for a 3G modem, first search for available mobile networks.
Procedure
1. Enter system view.
system-view
2. Enter cellular interface view.
controller cellular interface-number
3. (Optional.) Search for PLMNs.
plmn search
4. Configure a PLMN searching mode.
plmn select { auto | manual mcc mnc }
The default setting depends on the modem model.
5. Specify the network service to which the modem connects.
mode { 1xrtt | auto | evdo | gsm | gsm-precedence | hybrid | lte | td |
td-precedence | wcdma | wcdma-precedence }
The default setting for this command and support for the arguments depend on the modem
model.
6. (Optional.) Specify a GSM frequency band.
gsm band { egsm900 | gsm450 | gsm480 | gsm750 | gsm850 | gsm1800 | gsm1900
| pgsm900 | rsgm900 }
By default, no GSM frequency band is specified.
This command is supported only by Sierra MC7354 (ATT version) and MC7304 4G modules.
7. (Optional.) Specify a WCDMA frequency band.
wcdma band { wcdma800 | wcdma850 | wcdma900 | wcdma1700ip | wcdma1700us
| wcdma1800 | wcdma1900 | wcdma2100 | wcdma2600 }
By default, no WCDMA frequency band is specified.
This command is supported only by Sierra MC7354 (ATT version) and MC7304 4G modules.

Table of Contents

Other manuals for H3C SecPath F5030

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the H3C SecPath F5030 and is the answer not in the manual?

H3C SecPath F5030 Specifications

General IconGeneral
BrandH3C
ModelSecPath F5030
CategoryFirewall
LanguageEnglish

Related product manuals