13
Figure 18 PCH Configuration screen
4. On the screen as shown in Figure 19, select Configure SATA As, press Enter, and select an
operating mode.
Figure 19 Modifying the storage controller operating mode
Accessing the RSTe configuration screen
This section describes how to access the legacy BIOS configuration screen. To enter the RSTe
configuration screen, make sure a minimum of one embedded RSTe RAID controller is configured
to operate in RAID mode and each controller connects to a minimum of two drives. For how to set
the operating mode, see "Setting the RSTe operating mode."
To access the RSTe configuration screen:
To Next Page
Loading...
Need help?
General
