2-2
Feature Description
Switch Port
To connect your wireless network to your wired
network, you need a switch that is connected to
the AP.
Cabling
Make sure that a standard Ethernet cable with
straight-through wiring is installed at the site
before you install the AP.
Make sure that the cable is highly flexible and that
the RJ-45 connector has no extra covering that
could prevent the cable from being routed through
the mounting bracket.
Power
Requirement
Power is supplied using an 802.3af Power Over
Ethernet (PoE) compliant device such as a PoE
switch or a PoE injector. For maximum
performance, H3C recommends that you use a
Gigabit link.
MAC
Address
Record the AP MAC address in a safe place
before the AP is installed in a hard-to-reach
location.
The MAC address is printed on the back of the AP.
Mounting the AP
The AP can be mounted on the following types of surfaces:
z Wall or electrical box (NEMA enclosure)
z Table top
z Ceiling Mounting
To Next Page
Loading...
