H3C WA2620-AGN - Converting Your Managed AP (FIT) to a Stand-Alone AP (FAT); Converting Your Stand-Alone AP (FAT) to a Managed AP (FIT)

3-2
2) Launch your PC’s web browser. In the address bar, enter your
AP’s IP address and press Enter.
3) At the AP Login Screen, type the user name and password, and
the verification code, select the language (English and Chinese
are supported at present), and click Login. The default username
and password are case-sensitive:
z Username: admin
z Password: h3capadmin
For details on configuring your AP, see the H3C WA Series Access
Point User Manual and H3C WA Series WLAN Access Points
Web-Based Configuration Manual (FAT AP) or H3C WX Series
Access Controllers User Manual and H3C WX Series Access
Controllers Web-Based Configuration Manual (FIT AP)on our
website:
http://www.h3c.com
Converting your Managed AP (FIT) to a
Stand-alone AP (FAT)
If you plan to run this AP in stand-alone mode, without a wireless
controller, go to the web page at http://www.h3c.com to get the FAT
firmware and instructions.
Converting your Stand-alone AP (FAT) to a
Managed AP (FIT)
If you plan to run this AP in Managed AP mode with a wireless
controller, go to the web page http://www.h3c.com to get the
instructions.