H3C WA2620-AGN - 3 Connecting to the AP; Finding the IP Address on Networks with a DHCP Server(FIT AP); Finding the IP Address on Networks Without a DHCP Server(FAT AP); Log into the AP

3-1
3 Connecting to the AP
To connect to the AP, you must first determine the AP’s IP address in
one of these ways.
Finding the IP Address on Networks with a DHCP
Server(FIT AP)
If your network has a DHCP server, it automatically assigns an IP
address to the AP.
Finding the IP Address on Networks Without a DHCP
Server(FAT AP)
If your network does not have a DHCP server, the AP uses a default
factory configuration which includes the following information.
z Configure the IP address of the AP as 192.168.0.50.
z Configure the AP to enable the Telnet server function (the default
authentication username is admin, password is h3capadmin,
case sensitive). You can remotely manage and maintain the AP
through Telnet.
z Configure the AP to enable open-system authentication mode,
with the SSID being H3C.
Log into the AP
To Log into the AP after you determine its IP address, follows these
steps:
1) Connect the AP and PC, and ensure that the PC and AP can
communicate with each other properly.