2
Configure the terminal parameters as follows:
Bits per second—9,600.
Data bits—8.
Stop bits—1.
Parity—None.
Flow control—None.
Procedure
Verify that the AP is connected correctly to the configuration terminal and the configuration terminal
parameters are configured correctly. Then, power on the AP. You can see the following information
on the configuration terminal:
System is starting...
Booting Normal Extend BootWare.
……
System application is starting...
Startup configuration file does not exist.
User interface con0 is available.
Press ENTER to get started.
Logging in to the AP through Telnet
By default, HTTP and HTTPS are enabled and the following login information is defined for your
login:
Username—admin.
Password—h3capadmin.
Cloud mode
Some Intel wireless adapters do not support 802.11ax. For clients to detect Wi-Fi 6 networks,
upgrade the driver for the wireless adapter to the most recent version. For more information, see
the official statement of Intel.
To log in to the AP through a wireless connection:
1. Enable WLAN on the configuration terminal and access WLAN H3C_xxxxxx, where xxxxxx is
the last six bits of the AP's MAC address.
2. Enter
telnet wlan.h3c.com from the CLI of the terminal.
3. Enter the default username and password.
Anchor ACmode
When the AP operates in anchor AC mode, only wired connections are available.
Open a Web browser and visit 192.168.0.50 to log in to the device. If the device IP address has
been changed, contact your network administrator obtain the most recent configuration.
To Next Page
Loading...
