1
Preparing for installation
Safety recommendations
Safety labels
Hot surface warning label. A device attached with this label might have a hot surface
during operation. Install the device in a restricted access location. Only servicing
engineers or trained personnel can operate the devices in the access location.
General safety recommendations
professional technical personnel can install and remove the AP and its
accessories. You must
read all safety instructions carefully before working with the AP.
To avoid possible bodily injury and equipment damage, read the following safety recommendations
before installing the AP. Note that the recommendations do not cover every possible hazardous
condition.
To avoid bodily injury and device damage, take adequate safety measures.
Place the AP in a dry and flat location and take anti-slip measures.
Keep the AP clean and dust-free.
Do not place the AP in a moist area and avoid liquid intrusion.
Keep the AP and installation tools away from walkways.
Site preparation
Before installing the AP, examine the installation site and make sure the AP will operate in a
favorable environment. Make sure the temperature, humidity, and altitude at the installation site
meet the requirements in Table 1.
Table 1 Temperature, humidity, and altitude requirements
Operating temperature
–10°C to +55°C (32°F to 113°F)
Operating humidity
5% RH to 95% RH, noncondensing
Operating altitude –60 m to +5000 m (–196.85 ft to +16404.20 ft)
To Next Page
Loading...
