To Next Page
A
Austin WallaceJul 28, 2025
What to do if the Haaga 697 brushes are bent?
- KknapplaurenJul 28, 2025
If the brushes on your Haaga Blower are bent, it's likely due to improper storage. Straighten the brushes to resolve this.
What to do if the Haaga 697 brushes are bent?
If the brushes on your Haaga Blower are bent, it's likely due to improper storage. Straighten the brushes to resolve this.
Why is the sweeping performance of my Haaga Blower inadequate?
Inadequate sweeping performance of your Haaga Blower might be because the sweeping lip is missing, loose, or heavily worn. In this case, replace the sweeping lip.
What to do if my Haaga 697 sweeper moves sluggishly or doesn't run smoothly?
If your Haaga Blower sweeper isn't running smoothly, several factors could be the cause. The sweeper itself might be dirty, so cleaning it is advised. The brushes might be blocked; if so, eliminate the blockage. The brush drives could be dirty, requiring a cleaning. You can also lubricate brush drives with lubricant spray. The height adjustment might be set too low, or the contact pressure of the disc brushes might be too high, so adjust the height.
Why does my Haaga Blower sweeper switch off?
Your Haaga Blower sweeper might be switching off due to several reasons. The height adjustment could be set too low, or the contact pressure of the disc brushes might be too high, so you should adjust the height. Blocked brushes or an active overload protection could also cause this, so clean the sweeper and eliminate any blockages. Also, if the LED indicator on the sweeper lights up red, check the battery's charge and charge the battery if needed.
Lists uses that are not permitted for the machine.
Presents noise and vibration levels measured according to standards.
Lists technical specifications for the battery.
Lists technical specifications for the charger.
Detailed steps for attaching the push bar to the machine.
General
