haaga
677 / 697 / 697 plus
43
EN
29
28
27
Fig. 6: Component overview 6
Item no. Component
27 Switch plate
28 Fuse holder
29 Fuse F1
» The picture shows the components when the
cover is open or removed.
Construction and Function
5. Transport/transporting
5.1 Delivery
NOTE
Visible damage on the outer packing must be
immediately con rmed on delivery by the par-
cel service driver. If transport damage is only
noticed during unpacking, the parcel service
must be noti ed in writing within 24 hours after
delivery so that it can be liable for the damage.
5.2 Scope of supply
• Device
• Push bar
• Two handle ttings (pre-mounted)
• Charger with mains plug.
• Operating instructions
5.3 Handling Packaging Materials
• Always dispose of packing in an
environmentally responsible manner.
• Observe the local and regional legal
provisions in force.
5.4 Storage of sweeping machine
NOTE
Damage can be caused by improper storage
of the machine, e.g. in a damp environment,
with the battery lead attached, or with an
insu ciently charged battery. Information
regarding the storage and safekeeping of
the machine can be found in Chapter “10.
Decommissioning for Storage/Safekeeping”.
» In order to save space, the push bar can be
detached from the machine. Information on
the removal of the push bar can be found in
Chapter “10.1 Disassemble push bar” of this
operating manual.
Visible damage on the outer packing must be
immediately con rmed on delivery by the par-
cel service driver. If transport damage is only
noticed during unpacking, the parcel service
must be noti ed in writing within 24 hours after
delivery so that it can be liable for the damage.
Damage can be caused by improper storage
of the machine, e.g. in a damp environment,
with the battery lead attached, or with an
insu ciently charged battery. Information
regarding the storage and safekeeping of
the machine can be found in Chapter “10.
Decommissioning for Storage/Safekeeping”.
Transport/transporting
To Next Page
Loading...
