1. Push RUN/HALT.
2. Select an option.
Option Description
Start Program Starts the sampling program.
Note: The sampling program may not start immediately. Refer to Select when the
sampling program starts on page 14.
Halt Program Stops the sampling program temporarily. The status changes to Program Halted.
Resume Starts the sampling program from the point at which it was stopped.
Start From Beginning Starts the sampling program from the beginning.
End Program Stops the sampling program. The status changes to Program Complete.
Show data and alarms
Show the program status
1. Push STATUS or select Diagnostics>Status from the main menu.
2. If two sampling programs are in operation, select one of the sampling programs. The status of the
sampling program shows. In addition, the sample status, data log status, alarm status and
hardware status shows.
Status Description
Program Running The sampling program is in operation.
Program Halted The sampling program was stopped temporarily by the user.
Program Complete All of the programmed sample cycles are complete, or the sampling program was
stopped by the user.
3. To see more information, push the UP and DOWN arrow keys to select an option, then push
Select.
Option Description
Shows the name of the sampling program, quantity of samples collected and missed samples and
the time until the next sample is collected. When selected, the information that follows shows:
• Program start time
• Program start setting (Waiting On) (e.g., None, Delay, Schedule or Setpoint)
• Quantity of samples collected
• Quantity of missed samples
• Quantity of samples still to be collected
• Bottle number(s) of the next sample
• Time or counts to the next sample
• Time or counts to the last sample
• Quantity of bottles
• Program stop time
4
Shows the number of different measurements being recorded, the last time the measurement(s)
were recorded and the percentage of the data log memory that is used. When selected, the logging
interval and the last value recorded for each measurement shows.
4
Shows after the sampling program is complete or stopped.
English 19
To Next Page
Loading...
Need help?
General
