Attention: If you use a solar controller whose charging power is too low, the solar
controller may be damaged in the long run!
Maximum module power
Assemble
In order to guarantee appropriate operation, please read these operating
instructions including safety information completely and carefully before use.
During assemble ensure that the solar controller and any other system components
are mounted in such a way that is not accessible for children. Danger of life!
Do not mount the MPPT solar controller directly above a heat source! Ensure that
the battery is located in a well-ventilated room! Strictly ensure correct polarity!
Always ensure proper ventilation of solar controller. Never cover the ventilation slots
of the solar controller. Never use the device in the vicinity of highly flammable
materials.
Remember that large amounts of energy are stored in batteries. In case of
short-circuit; these energy quantities can be released in a short time. This means that
extreme heat may built up or a fire may break out at the site of short-circuit.
Connecting the solar charge controller
All components˄solar module,battery, consumers and MPPT solar controller˅must be adjusted to
each other concerning voltage and intensity of current. Check this information on the respective
type plate.In case of doubt, please contact your dealer.
To ensure safe operation, please strictly follow the correct order, when connecting the individual
To Next Page
Loading...
Need help?
General