1. Pull the transparent “Remove to Start” tag coming out of bat-
tery cap at the back of the lock and activate the lock.
2. Read the user manual and apply password change and
opening/closing operations several times before the mounting
of the lock.
3. Before mounting of the lock, switch lock handle to closing
position.
4. Make sure that there is no friction in the cabinet lids. If there is
a friction in the cabinet lids, make the hinge adjustments and
make the cabinet lid operable.
5. Do not forget to place Stop Cam depending on the condition
of the right or left lid of your cabinet.
6. Do not over-tighten nuts or screws. The maximum torque on
the cylinder screw is 2Nm.
7. Ensure that there is no friction between strike plate and the
cam.
8. Finally check the mounting screws, tighten the loose screws.
9. When placing the existing locks into place, if the cylinder hole
is big, use the adapter and do not over tighten the cylinder
nut. (max. 2Nm).
10. Check the cabinet lid hinge adjustment at least once a year.
Tighten loose screws.
WARNINGS FOR MOUNTING:
16
To Next Page
Loading...
Need help?
General
