hager 4500 - Page 6

Mortise Lock Exit Device
Installation Instructions
I-ED01553
Rev 4, Rev Date: 06/19/18 27390043 Page 6 of 10
8. INSTALL EXIT DEVICE (METAL DOORS ONLY)
Remove the chassis cover from the exit device. Put the exit device up against the door. Make sure the Latch Finger on the exit device
is inserted into the slot on the door and the mortise lock body and does not rub on the edges of the cutouts. Attach the exit device to
the door with the supplied ¼-20 x 3/8” Screws. Note: this is an optional step for convenience only and is not possible with wood
doors.
Latch Finger