Mortise Lock Exit Device
Installation Instructions
I-ED01553
Rev 4, Rev Date: 06/19/18 27390043 Page 8 of 10
11. HAND TRIM (NL AND DT FUNCTIONS ONLY)
For handing the NL and DT trim there is no spring cage. Position the handle in the proper orientation and install the handing pin.
Install the trim on the pull side of the door insuring that the handing pin is properly inserted into the lock body. The handing pin only
interacts with the lock body for the CE and BE functions. Use the supplied screws to bolt the trim to the door through the exit device
chassis. If installing mortise cylinder do not fully tighten screws yet.
13. INSTALL MORTISE CYLINDER (CE AND NL FUNCTIONS ONLY)
Loosen the cylinder retaining screw to allow the cylinder to be threaded into the lock case by inserting a screw driver with a #2 tip in
the hole on the mortise lock body. Install the mortise cylinder in the trim. Screw the cylinder into the lock body. The keyway must
end up on the bottom of the cylinder housing. Secure the cylinder by tightening the retaining screw. A 1-5/8” long cylinder is
required for these functions. Fully tighten mounting screws from previous step.
Cylinder retaining screw hole
To Next Page
Loading...
