hager TX216 - Page 25

hager
"DALI Gateway C00Cx2" software
Object table
Seite 25 von 130
Channel-oriented objects:
Function: Output switching
Object Function Name Type DP type Flag
0, 7, 14, … , 105
112, 118, …, 202
Switching
Group 1 ... 32 1-bit 1.001 C, W, -, (R)
1
Description: 1-bit object for switching a DALI group on or off
("1" = switching on; "0" = switching off).
Function: Output relative dimming
Object Function Name Type DP type Flag
1, 8, 15, … , 106
113, 119, …, 203
Dimming
Group 1 ... 32 4-bit 3.007 C, W, – (R)
1
Description: 4-bit object for the relative dimming of a DALI group.
Function: Output absolute dimming
Object Function Name Type DP type Flag
2, 9, 16, … , 107
114, 120, …, 204
Brightness value
Group 1 ... 32 1-byte 5.001 C, W, – (R)
1
Description: 1-byte object for setting an absolute dimming value (brightness value 0...255)
by the bus.
Function: Absolute dimming feedback
Object Function Name Type DP type Flag
3, 10, 17, … , 108
115, 121, …, 205
Brightness value
feedback
Group 1 ... 32 1-byte 5.001 C, -, T, (L)
1 2
Description: 1-byte object for transmitting feedback of an adjusted dimming value
(brightness value 0…255) to the bus.
Function: Switching feedback
Object Function Name Type DP type Flag
4, 11, 18, … , 109
116, 122, …, 206
Switching feedback
Group 1 ... 32 1-bit 1.001 C, -, T,( R)
1 2
Description: 1-bit object for transmitting feedback to the bus signalling the switching state
(“1” = switched on / “0” = switched off).
1
Each communication object can be read-out. The readout requires the setting of the R flag.
2
Depending on the parameterization the feedback objects are either actively transmitting (T flag) or can be passively read-out (R flag).