EN
Care and cleaning
21
Empty the water tank
During operation, steam condenses to water which is collected in the water tank. The tank
must be emptied after each drying cycle.
If the tank is full:
▶ the lamp
will fl ash during the programme.
▶ an acoustic signal will sound.
▶ the programme will automatically interrupted; the laundry remains wet.
▶ the „Start/Pause“
button must be pressed after the tank was emptied in order to
continue the programme.
WARNING!
Do not use the water for any kind of drinking or food processing.
CAUTION!
Following maintenance activities must be carried out after each drying cycle.
▶ Empty the water tank
▶ Clean the lint filter
▶ Clean the condenser fi lter
1. Pull out the water tank from its housing. Hold the
tank horizontally (fi g.: 33).
2. Empty the water tank into a sink (fi g.: 34).
3. Reinstall the water tank to the tumble dryer. (fi g.:
35).
The tank can also be emptied during programme. To
continue the programme the “Start/Pause”
button
has to be pressed after the tank has been reinstalled.
The symbol
only switches off after new programme
was started.
Notice
The condensed water can also be derived by a drain hose (enclosed or as an optional
accessory available at the customer service). The tank needs no longer be emptied (see
section ACCESSORY).
33 34
35
To Next Page
Loading...
