EN
Troubleshooting
All other Alarmcodes:
1. Note Alarmcode
2. Contact Service ; refer to CUSTOMER SERVICE.
25
Many occurring problems could be solved by yourself without specifi c expertise. In case
of a problem please check all shown possibilities and follow below instructions before you
contact an after sales service. See CUSTOMER SERVICE.
WARNING!
▶ Before maintenance, deactivate the appliance and disconnect the mains plug from
the mains socket.
▶ Electrical equipment should be serviced only by qualifi ed electrical experts, because
improper repairs can cause considerable consequential damages.
▶ A damaged power cable should only be replaced by the manufacturer, its service
agent or similarly qualifi ed persons in order to avoid a hazard.
Troubleshooting with display code
Code Cause Solution
Filters are clogged. Clean fi lters.
Ambient temperature is too low.
Only use the dryer at ambient
temperatures higher than 5 °C.
Drain pump error. Contact the customer service.
Temperature of the laundry in the drum does not change. Contact the customer service.
Communication failure between PCB and display. Contact the customer service.
The condenser thermal sensor is open-circuited
or short -circuited.
Contact the customer service.
Should the error codes reappear even after the taken measures, switch off the appliance,
disconnect the power supply and contact the customer service.
Information codes
Following codes are displayed only for information referring to the drying cycle. No meas-
ures must be performed.
Code Message
Automatic load detection is working.
:
The remaining programme time will be 1 hour and 25 minutes.
:
Delayed start of programme is activated. The start of programme cycle will
be in 7 hours.
The programme is fi nished. Switch off the appliance and remove the laundry.
To Next Page
Loading...
