EN
Accessories
29
Connection of a drain hose
With the drain hose (included or optional available
at the customer service; fi g.:55) the condensed wa-
ter can be redirected to the drain (sink, trap or gully;
fi g.:56). The draining of the water tank is eliminated.
Nevertheless the tank must be installed in the control
panel correctly.
1. Draw the drainpipe from the joint at the back of
the appliance (fi g.:57).
2. Connect the accessory drain hose to the discon-
nected drainpipe. Make sure both tubes are fi rmly
fi xed (fi g.:58).
3. The outlet of the drain hose must not be higher
than 1.0 m above the fl oor. If necessary the hose
can be shortened.
4. Secure the drain hose against slipping.
55 56
58
57
CAUTION!
▶ Use only the accessory hose set for the connection.
▶ The drain hose is never to be crushed, kinked, or twisted.
▶ The drain hose is not to be extended.
▶ Secure the drain hose against slipping. Otherwise the hose can slide off and running
condensed water may cause damage.
Wash-dryer stack
The arrangement to a space saving wash-dryer stack
is possible (fi g.:59). Not every washing machine is suit-
able for this purpose. Information, as well as the cor-
responding mounting kit are available via your local
dealer.
The mounting instructions supplied with the kit care-
fully inform about the installation steps.
59
To Next Page
Loading...
