EN
Troubleshooting
27
In case of power failure
In case of power failure, the current programme is stored only for a short time. Usually, a
restart of the programme is required.
WARNING!
Quickly remove all items and spread them out that the heat can be released.
Problem Possible cause Possible solution
Drying time is
too short.
• The load was too small?
• The laundry was too dry?
• For single items or small
amount of laundry the TIMER
programme should be selected.
• Select the TIMER programme
or a higher dry level.
Creasing at the
laundry.
• The tumble dryer is overloaded?
• The right programme was se-
lected?
• Reduce the amount of laundry.
• Remove laundry immediately
after programme end, hang
them up and pull them into
shape.
• Select and adjust the pro-
gramme according to the fab-
ric type.
Door does not
close.
• Laundry is clamped between
door and gasket?
• Insert laundry correctly.
Remaining time
on the display
stops or skips.
• The remaining time will be ad-
justed continuously based
upon the following factors:
- Type of laundry.
- Loaded amount.
-
Moisture degree of the laundry
.
- Ambient temperature.
• The automatic adjustment is a
normal operation.
The drum interi-
or light does not
work.
• Appliance is connected to the
power supply?
• The appliance has been
switched on?
• The light bulb is still functional?
• Check power supply
• Switch the machine on.
• Contact the customer service
to replace the lamp.
To Next Page
Loading...
