Installation
Waiting time
Maintenance-free lubrication oil is located in the
capsule of the compressor. This oil may get through
closed pipe system during transportation. Before con-
necting the appliance to the power supply you have to
wait 2 hours so that the oil runs back into the capsule.
Electrical connection
Aligning the appliance
The appliance should be placed on a at and solid sur-
face.
1. Tilt the appliance slightly backwards.
2. Set the feet to the desired level.
Make sure the distance to the wall on the hinge side is
at least 100mm for the door to open properly.
3. The stability can be checked by alternately bump-
ing on the diagonals. The slightly swaying should
be the same in both directions. Otherwise the
frame can warp; possible leaking door seals are
the result. A lowering of the rear feet facilitates the
door.
1. 2.
3.
WARNING!
To avoid risks, a damaged power cord must be replaced by customer services (see war-
ranty card).
Before each connection check if:
▶ power supply, socket and fusing are appropriate to the rating plate.
▶ the power socket is earthed and no multi-plug or extension is being used.
▶ the power plug and socket are of sound condition.
Connect the plug to a properly installed household socket.
34
To Next Page
Loading...
